材料科学
烧结
闪光灯(摄影)
惠斯通大桥
印刷电子产品
柔性电子器件
聚酰亚胺
微观结构
辐照
扫描电子显微镜
基质(水族馆)
光电子学
纳米颗粒
铜
复合材料
墨水池
纳米技术
光学
冶金
电气工程
核物理学
图层(电子)
海洋学
电压
电阻器
工程类
地质学
物理
作者
Hyun-Jun Hwang,Wan-Ho Chung,Hak‐Sung Kim
出处
期刊:Nanotechnology
[IOP Publishing]
日期:2012-11-09
卷期号:23 (48): 485205-485205
被引量:154
标识
DOI:10.1088/0957-4484/23/48/485205
摘要
In this work, a flash-light sintering process for Cu nanoinks was studied. In order to precisely monitor the milliseconds flash-light sintering process, a real-time Wheatstone bridge electrical circuit and a high-rate data acquisition system were used. The effects of several flash-light irradiation conditions (irradiation energy, pulse number, on-time, and off-time) and the effects of the amount of poly(N-vinylpyrrolidone) in the Cu nanoink on the flash-light sintering process were investigated. The microstructures of the sintered Cu films were analyzed by scanning electron microscopy. To investigate the oxidation or reduction of the oxide-covered copper nanoparticles, a crystal phase analysis using x-ray diffraction was performed. In addition, the sheet resistance of Cu film was measured using a four-point probe method. From this study, it was found that the flash-light sintered Cu nanoink films have a conductivity of 72 Ωm/sq without any damage to the polyimide substrate. Similar nanoinks are expected to be widely used in printed and flexible electronics products in the near future.
科研通智能强力驱动
Strongly Powered by AbleSci AI