材料科学
曝气
复合材料
索特平均直径
冶金
喷雾特性
喷嘴
机械
环境科学
工艺工程
作者
D. Ajay Vincent Raj,Rajesh Sadanandan
标识
DOI:10.1615/atomizspr.2026061868
摘要
An experimental investigation of the spray characteristics of a twin-fluid swirl co-axial aerated injector (SCAI) is reported. The objective is to understand the effect of increasing the gas-to-liquid ratio (GLRm), injection pressure (pi), liquid mass flow rate (mi), and swirl intensity (MR) on atomization. Isothermal measurements employing optical and laser-based techniques are performed with water as the surrogate fuel, air as the aeration fluid, and a co-axial swirl medium. With an increase in GLRm, the spray morphology transitioned from annular to flow-blurring (FB), with notable improvements in atomization and spray dilution. For a fixed mi, the spray cone angle increased with GLRm and pi. Though the spray breakup mechanism remained unchanged with increasing pi, a marginal decrease in SMD and enhanced dilution were evident. The study also revealed a strong correlation of SMD with two-phase flow bulk velocity vm at the nozzle exit when compared to mi or Qa or GLRm alone for a fixed pi. With the investigated configuration of the swirl module, the swirl intensity had only a minimal impact on the twin-fluid spray and atomization characteristics. At higher pi, the influence of MR on the droplet velocities diminishes.
科研通智能强力驱动
Strongly Powered by AbleSci AI