材料科学
搅拌摩擦加工
共晶体系
合金
冶金
极限抗拉强度
搅拌摩擦焊
摩擦学
母材
微观结构
韧性
金属间化合物
粒度
复合材料
延伸率
动态再结晶
再结晶(地质)
铝合金
延展性(地球科学)
降水
严重塑性变形
相(物质)
Twip公司
沉淀硬化
摩擦系数
摩擦系数
压痕硬度
作者
Nafiseh Abassi,Salman Nourouzi,Hamed Jamshidi Aval
摘要
ABSTRACT In this study, the microstructural evolution, mechanical performance, and tribological behavior of an Al‐9.2Si‐4.9Cu‐0.7 Mg alloy subjected to friction stir processing (FSP) were systematically investigated. Plates were processed at tool traverse speeds of 40, 60, and 80 mm/min (P‐40, P‐60, and P‐80), while extreme conditions (20 and 100 mm/min) were excluded due to tunnel defect formation. FSP refined the as‐cast coarse microstructure, reducing average grain size from ∼5.2 μm at 40 mm/min to ∼2.6 μm at 80 mm/min through dynamic recrystallization and particle‐stimulated nucleation. Simultaneously, fragmentation and uniform redistribution of eutectic Si and Cu/Fe‐rich intermetallics improved phase homogeneity, while nanoscale Al 2 Cu (Θ‐phase) precipitates contributed to precipitation strengthening. Hardness measurements revealed an increase from 108.6 ± 2.8 HV in the base alloy to 157.1 ± 1.2 HV (P‐40) and 171.8 ± 2.4 HV (P‐80). Tensile strength improved markedly from 273.5 ± 10.1 MPa in the as‐cast alloy to 492.1 ± 10.2 MPa (P‐40) and 596.5 ± 9.7 MPa (P‐80), accompanied by enhanced elongation (from 1.14% ± 0.4% to 2.8%–3.1%) and toughness (from 257.9 ± 8.9 MJ·m −3 to > 1400 MJ·m −3 ). Wear resistance was also significantly enhanced, as the wear rate decreased from 6.9 ± 0.2 μg/m in the base alloy to 4.1 ± 0.3 μg/m (P‐40) and 3.5 ± 0.2 μg/m (P‐80), while the friction coefficient was reduced from 0.54 ± 0.03 to 0.31 ± 0.02.
科研通智能强力驱动
Strongly Powered by AbleSci AI