聚苯胺
电导率
苯胺
化学
聚合
聚苯胺纳米纤维
盐酸盐
化学工程
电阻率和电导率
聚合物
高分子化学
核化学
有机化学
物理化学
电气工程
工程类
作者
Jaroslav Stejskal,Robert G. Gilbert
标识
DOI:10.1351/pac200274050857
摘要
Abstract Eight persons from five institutions in different countries carried out polymerizations of aniline following the same preparation protocol. In a "standard" procedure, aniline hydrochloride was oxidized with ammonium peroxydisulfate in aqueous medium at ambient temperature. The yield of polyaniline was higher than 90 % in all cases. The electrical conductivity of polyaniline hydrochloride thus prepared was 4.4 ± 1.7 S cm -1 (average of 59 samples), measured at room temperature. A product with defined electrical properties could be obtained in various laboratories by following the same synthetic procedure. The influence of reduced reaction temperature and increased acidity of the polymerization medium on polyaniline conductivity were also addressed. The conductivity changes occurring during the storage of polyaniline were monitored. The density of polyaniline hydrochloride was 1.329 g cm -3 . The average conductivity of corresponding polyaniline bases was 1.4 x108 S cm -1 , the density being 1.245 g cm -1 . Additional changes in the conductivity take place during storage. Aging is more pronounced in powders than in compressed samples. As far as aging effects are concerned, their assessment is relative. The observed reduction in the conductivity by ~10 % after more than one-year storage is large but, compared with the low conductivity of corresponding polyaniline (PANI) base, such a change is negligible. For most applications, an acceptable level of conductivity may be maintained throughout the expected lifetime.
科研通智能强力驱动
Strongly Powered by AbleSci AI