Supramolecular and adaptable covalent polyethylene networks

作者
Arkadiusz Żych
摘要

Polyethylene (PE) is the most widely used commodity thermoplastic due to its good solvent resistance, excellent flexibility, low cost and ease of processing. It finds application in common objects like plastic bags, packaging, automotive, medicine, aerospace and electronics.1, 2 However, its use is limited by low melting point, stress cracking and poor wear resistance. To overcome those issues and expand its applications, crosslinking of polyethylene is used. Crosslinking forms a high molecular weight network, which improves impact strength, stress cracking resistance, creep and abrasion resistance without altering significantly tensile strength and density.3, 4\nDespite the numerous advantages of crosslinked polyethylene (PEX) and its wide applications, recycling is a major drawback. Because of the crosslinking, PEX does not flow after melting and cannot be reprocessed like a thermoplastic. Most of the PEX waste is currently landfilled or incinerated which is a major problem both for the environment as well as for a recovery of valuable materials.5, 6 \nPE network that could be de-crosslinked at will or crosslinked using dynamic covalent crosslinkers would be easy to process and recycle while keeping benefits of PEX. The objective of this thesis is to explore properties and potential applications of PE crosslinked using physical or dynamic covalent crosslinkers. \nChapter 2 is focused on ureidopyrimidinone (UPy) functionalized polyethylene with enhanced mechanical properties. UPy was readily introduced into various PEs bearing hydroxy groups by solution grafting, affording physically crosslinked PE via supramolecular interactions. Utilizing low melting UPy where its methyl group is substituted with the isopropyl one (isopropyl UPy, IPR UPy), reactive extrusion process was developed that allowed to significantly shorten the reaction time and eliminate the use of solvents and catalysts. Chemical structures were confirmed by Fourier transform infrared spectroscopy (FT IR) and proton nuclear magnetic resonance (1H NMR). Differential scanning calorimetry (DSC), rheology and dynamical mechanical thermal analysis (DMTA) were employed to investigate thermal stability of the obtained polymers and revealed that UPy functionalized PE can be safely processed using techniques like compression molding and extrusion below 150 °C. Introduction of UPy significantly improved mechanical properties and altered rheology showing that quadruple hydrogen bonding interactions are present both in the solid state and in the PE melt up to 150 °C after which UPy starts to degrade before it can dissociate. \nThe development of pyrene grafted polyethylene as a strain detector is described in Chapter 3. High density and very low density polyethylene graft maleic anhydride (HDPE MAH and VLDPE MAH respectively) functionalized with 1 aminopyrene (AP) were prepared via reactive extrusion. The resulting strain-reporting PE retains similar mechanical, thermal and rheological properties to that of the starting PE MAH materials. Fluorescent emission spectroscopy revealed pronounced changes in fluorescent behavior under stress due to the breakup of the pyrene excimers. For HDPE MAH AP this change was very sudden with a clear drop of excimer content (IE/IM) of around 50 % due to necking of the material stretched above 50 % strain. In contrast, VLDPE MAH AP showed no necking and a linear decrease of IE/IM ratio down to around 30 % when elongation up to 1100 % strain was reached while HDPE MAH AP broke after 200 % strain.\nOxygen and water vapor barrier properties of PE HEMA functionalized with UPy (ureidopyrimidinone) or MIP (1 methylisocyanatopyrene) are investigated in Chapter 4. Functionalization of PE HEMA1 with 2.2 mol% of UPy decreased OP (oxygen permeability) by about 30 % at 23 °C and 0 % RH (relative humidity) and about 25 % at 38 °C and 50 % RH and WVP (water vapor permeability) by about 25 %. When 1.2 mol% of MIP was introduced into PE HEMA1, OP was decreased by about 35 % at 23 °C and 0 % RH and about 30 % at 38 °C and 50 % RH and WVP by about 40 %. Despite the achieved improvements the samples did not performed as well as the commercially available EVOH based multilayer structure used as a reference.\nSynthesis and characterization of polyethylene silyl ether vitrimers is discussed in Chapter 5. PE was dynamically crosslinked directly via reactive extrusion using commercially available N,N' Bis[3 (trimethoxysilyl)propyl] ethylenediamine (TMSPEDA). This fast and efficient process allowed to produce PE vitrimers without any synthetic effort or use of any solvent which makes it environmentally friendly and easy to upscale. Dynamic crosslinking transformed thermoplastic PE into an elastic solid with greatly improved melt strength as revealed by DMTA and rheology. Mechanical properties could be tuned by varying the amount of TMSPEDA crosslinker. All prepared vitrimers were insoluble in xylene and were not affected by moisture, demonstrating crosslinked character and excellent solvent and hydrolysis resistance. Despite the crosslink nature dynamic silyl ether exchange enabled processability and recyclability of this system.\n\nReferences\n1.\tKaminsky, W., Polyolefins: 50 Years after Ziegler and Natta Ii. Springer: 2013.\n2.\tVasile, C., Handbook of Polyolefins. CRC Press: 2000.\n3.\tGhosh, P., Polymer Science and Technology. Tata McGraw-Hill Education: 1990.\n4.\tPlatzer, N., Encyclopedia of Polymer Science and Engineering. Wiley: 1986.\n5.\tShang, L.; Wang, S.; Zhang, Y.; Zhang, Y. Pyrolyzed Wax from Recycled Cross-Linked Polyethylene as Warm Mix Asphalt (Wma) Additive for Sbs Modified Asphalt. Constr. Build. Mater. 2011, 25, 886-891.\n6.\tLee, H.-s.; Jeong, J. H.; Cho, H.-K.; Koo, C. M.; Hong, S. M.; Kim, H.; Lee, Y.-W. A Kinetic Study of the Decross-Linking of Cross-Linked Polyethylene in Supercritical Methanol. Polym. Degrad. Stab. 2008, 93, 2084-2088.

科研通智能强力驱动
Strongly Powered by AbleSci AI
科研通是完全免费的文献互助平台,具备全网最快的应助速度,最高的求助完成率。 对每一个文献求助,科研通都将尽心尽力,给求助人一个满意的交代。
实时播报
刚刚
qianzhihe发布了新的文献求助10
刚刚
单薄冰安发布了新的文献求助30
刚刚
刚刚
2秒前
共谁书半生完成签到 ,获得积分10
3秒前
4秒前
4秒前
6秒前
李麟发布了新的文献求助10
7秒前
7秒前
刘泽楷发布了新的文献求助10
8秒前
乐乐的应助被芦苇采纳,获得10
8秒前
Lucas的应助被喵喵采纳,获得10
8秒前
9秒前
For-t-完成签到 ,获得积分10
9秒前
a61完成签到,获得积分10
9秒前
雨林连笛发布了新的文献求助10
10秒前
hey发布了新的文献求助10
10秒前
Jasper的应助被HUYAOWEI采纳,获得10
11秒前
11秒前
12秒前
12秒前
12秒前
bin_zhang完成签到,获得积分10
13秒前
盏盏发布了新的文献求助10
13秒前
岳志伟完成签到 ,获得积分10
13秒前
怕黑的白玉完成签到,获得积分10
13秒前
14秒前
zzyh完成签到,获得积分10
14秒前
14秒前
14秒前
14秒前
14秒前
15秒前
15秒前
15秒前
15秒前
轩辕十四完成签到,获得积分10
16秒前
斯文败类的应助被Akiba采纳,获得10
16秒前
高分求助中
(应助此贴封号)【重要!!请各用户(尤其是新用户)详细阅读】【科研通的精品贴汇总】 10000
拉伸高分子熔体中缠结行为的模拟和小角中子散射研究 1700
The World Atlas of Wine 9th edition 1000
奈特基础组织学:配套组织病理学(第4版)(Netter's Essential Histology With Correlated Histopathology) 800
八旗制度の研究 600
高分子基功能界面水蒸发材料与应用研究 500
外场增强的水汽发电研究 500
热门求助领域 (近24小时)
化学 材料科学 医学 生物 纳米技术 计算机科学 工程类 有机化学 化学工程 生物化学 物理 复合材料 内科学 催化作用 光电子学 人工智能 细胞生物学 无机化学 物理化学 数学
热门帖子
关注 科研通微信公众号,转发送积分 8188210
求助须知:如何正确求助?哪些是违规求助? 9576001
关于积分的说明 21844898
捐赠科研通 7786081
什么是DOI,文献DOI怎么找? 3435220
关于科研通互助平台的介绍 2559559
邀请新用户注册赠送积分活动 2482139