The Effect of High Charge Rate Cycling on Coulombic Efficiency Measurements

法拉第效率 工作(物理) 化学 离子 锂(药物) 自行车 分析化学(期刊) 热力学 材料科学 电极 物理 电化学 物理化学 色谱法 有机化学 考古 内分泌学 历史 医学
作者
John Chris Burns,Jeff R. Dahn
出处
期刊:Meeting abstracts [Institute of Physics]
卷期号:MA2014-02 (5): 347-347
标识
DOI:10.1149/ma2014-02/5/347
摘要

Recent work has shown good correlation between short term measurements of the coulombic efficiency and long term capacity retention during relatively slow cycling (greater than 20 hours per cycle) and high temperature (above room temperature) [1-3] using the High Precision Charger built at Dalhousie University which is able to measure coulombic efficiency to < 0.01% error [4]. Smith et al. [5] studied how the charge rate impacts the coulombic efficiency in commercial cylindrical cells of different positive electrodes and graphite negative electrodes at different temperatures. This work showed that the departure of the coulombic efficiency from the ideal value of 1.00000 was dependant on the time of one cycle and independent of charge rate for slow rates and elevated temperatures. This work could not investigate the dependence of coulombic efficiency on high charge rates due to limitations of the equipment. Smith et al. [5] showed that as the charge rate of Li-ion cells was increased from ~C/100 to ~C/20, the coulombic efficiency (CE) increased such that (1 – CE) = k*t, where k is a constant that increases with temperature and t is the time of one charge-discharge cycle. Extending this idea to higher cycle rates means that at very high rates the coulombic efficiency approaches 1.00000 since there is very little time per cycle for degradation. However, it is well known that lithium plating can occur at high charge rates with graphite negative electrodes [6, 7] and this would lower the coulombic efficiency. It has been shown that the coulombic efficiency of plating and stripping metallic lithium from graphite electrodes is 0.97-0.98 [8] compared to the coulombic efficiency of intercalating and de-intercalating lithium from a graphite electrode which is > 0.995 [9]. Therefore as the charge rate continues to increase past the onset of lithium plating, the coulombic efficiency should begin to depart further from 1.00000 as a larger fraction of the lithium is involved in plating/stripping instead of intercalation/de-intercalation reactions. Figure 1 shows CE versus charge rate results for two temperatures that shows the time dependent degradation regime at low rates on the left (low rates) and the regime governed by lithium plating on the right (high rates). This study will show results of high charge rate cycling on Li[Ni1/3Mn1/3Co1/3]O2 (NMC)/graphite cells at different temperatures to more thoroughly understand the shape of these curves and the impact of lithium plating on precision measurements of coulombic efficiency and endpoint capacity slippage. This behavior needs to be well understood as many applications for Li-ion batteries, including electrified vehicles, desire high charge rates. References: [1] J.C. Burns, G. Jain, A.J. Smith, K.W. Eberman, E. Scott, J.P. Gardner, and J.R. Dahn, J. Electrochem. Soc., 158, A255-A261 (2011). [2] J.C. Burns, N.N. Sinha, D.J. Coyle, G. Jain, C.M. VanElzen, W.M. Lamanna, A. Xiao, E. Scott, J.P. Gardner, and J.R. Dahn, J. Electrochem. Soc., 159, A85-A90 (2012). [3] A.J. Smith, H.M. Dahn, J.C. Burns, and J.R. Dahn, J. Electrochem. Soc., 159, A705-A710 (2012). [4] HPC [5] A.J. Smith, J.C. Burns, and J.R. Dahn, Electrochem. Solid-State Lett., 13, A177-A179 (2010). [6] S.S. Zhang, J Power Source, 161, 1385-1391 (2006). [7] W. Lu, C.M. Lopez, N. Liu, J.T. Vaughey, A. Jansen, and D.W. Dees, J. Electrochem. Soc., 159, A566-A570 (2012). [8] L.E. Downie, L.J. Krause, J.C. Burns, L.D. Jensen, V.L. Chevrier, and J.R. Dahn, J. Electrochem. Soc., 160, A588-A594 (2013). [9] A.J. Smith, J.C. Burns, X. Zhao, D. Xiong, and J.R. Dahn, J. Electrochem. Soc., 158, A447-A452 (2011).

科研通智能强力驱动
Strongly Powered by AbleSci AI
科研通是完全免费的文献互助平台,具备全网最快的应助速度,最高的求助完成率。 对每一个文献求助,科研通都将尽心尽力,给求助人一个满意的交代。
实时播报
1秒前
2秒前
科研通AI6.3的应助被柠浩采纳,获得10
2秒前
可爱的函函的应助被别玉玉采纳,获得10
2秒前
2秒前
1111222完成签到,获得积分10
3秒前
Jasper的应助被未知旋律采纳,获得10
3秒前
3秒前
4秒前
Tink完成签到,获得积分0
5秒前
lyj完成签到 ,获得积分10
5秒前
科研通AI6.4的应助被Halo采纳,获得10
5秒前
iceanbecky发布了新的文献求助30
7秒前
Caboda发布了新的文献求助10
8秒前
要减肥发布了新的文献求助10
8秒前
zz发布了新的文献求助10
8秒前
wanghongyue完成签到,获得积分10
8秒前
二十一日完成签到,获得积分10
9秒前
CodeCraft的应助被洁净的千凡采纳,获得10
9秒前
GBY发布了新的文献求助10
9秒前
baiying发布了新的文献求助10
10秒前
澍归发布了新的文献求助10
10秒前
12秒前
syvshc的应助被369ninja采纳,获得10
13秒前
13秒前
13秒前
13秒前
14秒前
qqqqq完成签到,获得积分20
14秒前
呆萌的青烟完成签到,获得积分10
15秒前
Ditf发布了新的文献求助10
16秒前
斯文钢笔发布了新的文献求助10
18秒前
爱撒娇的天磊完成签到,获得积分10
18秒前
菠菠完成签到,获得积分20
18秒前
水煮电吹风的应助被suhang2024采纳,获得10
19秒前
酷炫蛋挞发布了新的文献求助10
19秒前
乔清发布了新的文献求助30
19秒前
天天开心完成签到,获得积分10
20秒前
鲸鱼完成签到 ,获得积分10
20秒前
希望天下0贩的0的应助被zzzz采纳,获得10
20秒前
高分求助中
(应助此贴封号)【重要!!请各用户(尤其是新用户)详细阅读】【科研通的精品贴汇总】 10000
拉伸高分子熔体中缠结行为的模拟和小角中子散射研究 1700
奈特基础组织学:配套组织病理学(第4版)(Netter's Essential Histology With Correlated Histopathology) 800
John McDowells Bildungstheorie 800
八旗制度の研究 600
plantTFDB 508
高分子基功能界面水蒸发材料与应用研究 500
热门求助领域 (近24小时)
化学 材料科学 医学 生物 纳米技术 计算机科学 工程类 有机化学 化学工程 生物化学 物理 复合材料 内科学 催化作用 光电子学 人工智能 细胞生物学 无机化学 物理化学 数学
热门帖子
关注 科研通微信公众号,转发送积分 8177849
求助须知:如何正确求助?哪些是违规求助? 9568641
关于积分的说明 21800145
捐赠科研通 7772473
什么是DOI,文献DOI怎么找? 3432537
关于科研通互助平台的介绍 2556720
邀请新用户注册赠送积分活动 2478067