高锰酸盐
臭氧
化学
环境化学
无机化学
有机化学
作者
Yanjun Jiang,Joseph E. Goodwill,John E. Tobiason,David A. Reckhow
出处
期刊:Acs Symposium Series
[American Chemical Society]
日期:2016-01-01
卷期号:: 421-437
被引量:8
标识
DOI:10.1021/bk-2016-1238.ch016
摘要
This study compared the effects of ferrate (Fe(VI)) and ozone pre-oxidation on disinfection byproduct (DBP) formation from subsequent chlorination using batch experiments, and the effects of Fe(VI) and Mn(VII) using continuous flow experiments. In the batch experiments, two natural waters were collected and treated at bench scale under three oxidation scenarios (chlorine, ferrate oxidation followed by chlorination, and ozonation followed by chlorination). The effects of pre-oxidant dose and bromide concentration on DBP formation potentials were also determined. Results showed that ferrate and ozone pre-oxidation were comparable at equivalent doses for most DBP precursor removal. A net decrease in trihalomethane (THM), dihaloacetic acid (DHAA), trihaloacetic acid (THAA), and dihaloacetonitrile (DHAN) yield, while an increase in chloropicrin (CP) yield, were caused by both pre-oxidants. Ozone led to higher formation potentials of haloketones (HKs) and CP than ferrate at the same mass dose. The relative performance of ferrate versus ozone for DBP precursor removal was affected by water quality (e.g., nature of organic matter), DBP species, oxidant dose, and bromide concentration. In continuous flow experiments, the use of Fe(VI) pre-oxidation resulted in improved finished water quality as measured by UV 254 absorbance, turbidity and DBPFP compared to waters with no pre-oxidation, or those pre-oxidized with Mn(VII).
科研通智能强力驱动
Strongly Powered by AbleSci AI