The effect of rolling temperature on the microstructure and properties of multi pass rolled 7A04 aluminum alloy

The current research on 7-series aluminum alloys mainly focuses on solid solution and aging treatments, as well as the flow stress during the deformation process. There are limited researches on the influence of thermal deformation temperature on the microstructure and properties of the aluminum alloy during multi-pass hot rolling process. In this study, the as-cast 7A04 aluminum alloy was subjected to homogenization treatment, followed by multi-pass hot rolling. The effects of different deformation parameters on dislocation density were analyzed. Microstructural characterization of the deformed alloy was performed using optical microscopy (OM), scanning electron microscopy (SEM) with energy-dispersive spectroscopy (EDS), X-ray diffraction (XRD), and micro-hardness tester. The optimal microstructure of the deformed alloy was selected based on the size of recrystallization. Subsequently, the Deform–3D finite element simulation software was used to analyze the multi-pass hot rolling process. The influence of deformation parameters on the uniformity of equivalent strain distribution within the samples was investigated. The results showed that at the deformation temperature of 430 °C, a significant amount of recrystallized microstructure appeared in the alloy, resulting in the lowest dislocation density and a significant reduction in the quantity of coarse precipitates. Finite element numerical simulation revealed that the deformation temperature had a certain influence on the uniformity of strain distribution within the alloy. However, this influence was mostly eliminated when the deformation temperature exceeded 380 °C. Meanwhile, the distribution of strain within the alloy was found to be related to the temperature distribution.