Mechanism of sulfate attack: A fresh look

This paper reports the results of an investigation on the effects of sodium and magnesium sulfate solutions on expansion and microstructure of different types of Portland cement mortars. The effects of using various sulfate concentrations and of using different temperatures are also reported. The results suggest that the expansion of mortars in sodium sulfate solution follows a two-stage process. In the initial stage, Stage 1, there is little expansion. This is followed by a sudden and rapid increase in the expansion in Stage 2. Microstructural studies suggest that the onset of expansion in Stage 2 corresponds to the appearance of cracks in the chemically unaltered interior of the mortar. Beyond this point, the expansion proceeds at an almost constant rate until the complete deterioration of the mortar specimen. In the case of magnesium sulfate attack, expansion occurs at a continually increasing rate. Microstructural studies suggest that a layer of brucite (magnesium hydroxide) on the surface forms almost immediately after the introduction of the specimens into the solution. The attack is then governed by the steady diffusion of sulfate ions across the brucite surface barrier. The ultimate failure of the specimen occurs as a result of the decalcification of the calcium silicate hydrate (C-S-H), and its conversion to magnesium silicate hydrate (M-S-H), after prolonged exposure to the solution. The effects of using various admixtures, and of changing the experimental variables such as the temperature and concentration of the solution, are also summarized in this paper. Models for the mechanism of the attack resulting from sodium and magnesium sulfate solutions will be presented in Part 2.