Kinetic Investigation of the Deep Desulfurization of 5 wt% Si High-Silicon Austenitic Stainless Steel

Given the demand for extremely low sulfur content in 5 wt% Si high-silicon austenitic stainless steel (SS-5Si), smelting utilizes a slag composition of CaF2-CaO-Al2O3-MgO-SiO2 with a basicity of 1 to 3, Al2O3 content ranging from 2.04 to 9.61%, and CaF2 content between 20.8 and 31.62%. Experiments designed to investigate the sulfur content in molten steel at temperatures of 1773 K, 1823 K, and 1873 K over durations of 1, 5, 10, 15, and 30 min, under varying slag compositions, corroborated with a theoretically derived model hypothesizing a “rate-controlling” step in mass transfer, revealed that the mass transfer of sulfur within the molten steel was determined to be the rate-controlling step (RCS) in the (CaO) + [S] = (CaS) + [O] reaction kinetics, and the variability of the mass transfer coefficient of sulfur, kS,m, in the molten steel ranged from 1.04 × 10−5 m∙s−1 to 2.24 × 10−5 m∙s−1. Based on the temperature dependency of kS,m, the apparent activation energy for the desulfurization reaction was estimated to be 96.03 kJ/mol. Considering the slag components, the binary basicity, denoted as R, exerted an overriding influence on the process of desulfurization. At a basicity of 1, the sulfur content within the liquid steel was reduced, from 22 ppm to 11 ppm within a time span of 30 min. In contrast, an increase in the basicity to a value of 3 showed a significant consequence: over an identical temporal duration of 30 min, the sulfur content was drastically reduced to 2.2 ppm. By contrast, an initial surge in desulfurization rates is observed within the first five minutes, attributable to relatively lower concentrations of Al2O3 and higher levels of CaF2. Subsequently, these parameters exert no significant influence on the kinetics of the desulfurization process.