Superelastic Properties of Aged FeNiCoAlTaB Cold-Rolled Shape Memory Alloys

In the present study, microstructure and cyclic tensile tests were used to measure the superelastic responses of Fe40.95Ni28Co17Al11.5Ta2.5B0.05 (at.%) shape memory alloys after 97% cold rolling. Cold-rolled samples underwent annealing heat treatment (1250 °C/1 h) followed by quenching in water or aging heat treatment (700 °C/6 h and 700 °C/12 h) followed by quenching in water. The microstructure results showed that the average grain size increased from 210 μm to 1570 μm as annealing times increased from 0.5 h to 1 h. X-ray diffraction (XRD) spectra for FeNiCoAlTaB (NCATB) showed that in cold-rolled alloys after solution, the strong peak was in the face-centered cubic (γ, FCC) <111> structure. In aged samples, a new peak (γ’, FCC) emerged, the intensity of which increased as aging times rose from 6 to 12 h. Transmission electron microscope (TEM) images showed that the average precipitate size was around 10 nm in 700 °C/6 h specimens and 18 nm in 700 °C/12 h specimens. The precipitate was enriched in Ni, Al, and Ta elements and exhibited an L12 crystal structure. Tensile samples aged at 700 °C for 6 and 12 h exhibited recoverable strains of 1% and 2.6%, respectively, at room temperature. Digital image correlation (DIC) results for the sample aged at 700 °C for 12 h showed that two martensite variants were activated during the superelastic test. Such variants can form corresponding variant pairs (CVPs), which promote tensile deformation. The tensile sample exhibited a gradual cyclic degradation, and a large irrecoverable strain was observed after the test. This irrecoverable strain was the result of residual martensite, which was pinned by dislocations.