Removal of fluoride using platanus acerifoli leaves biochar – an efficient and low-cost application in wastewater treatment

The fluoride with high-concentration in industrial wastewater will cause great harm to the environment and calcium-modified biochar is an effective adsorbent for the removal of fluoride. Biochar composites were prepared from mature and dried dead leaves and eggshell to remove fluoride from the aqueous solution. The effects of raw material ratio, pH, contact time, adsorbent dosage, temperature, initial concentration of fluoride, and the coexisting ions on the removal efficiency of fluoride were explored. The biochar composites before and after fluoride removal were characterized by the SEM, FTIR, XRD, and XPS, which showed CaF2 precipitation was formed during the adsorption. The kinetics and isotherm study showed that chemical adsorption was the primary step for the fluoride adsorption of the biochar composites. The removal efficiency of fluoride can reach 98.53% when the amount of adsorbent was 1.6 g/L and the fluoride concentration was 500 mg/L. The BET-specific surface area of platanus acerifoli leaves biochar was 410.14 m2/g, which was suitable for the adsorption carrier. The adsorption capacity of the biochar composite materials was as high as 308 mg/g. The platanus acerifoli leaves-eggshell biochar composite with large pore size and high removal efficiency may be used as an efficient and low-cost adsorbent for treating high-concentration fluoride-containing wastewater.