可用的
瞬态(计算机编程)
热水器
核工程
体积热力学
热泵
蓄热式加热器
机械工程
工程类
材料科学
热能储存
管(容器)
工艺工程
计算机数据存储
储水式热水器
汽车工程
水冷式
试验数据
储罐
环境科学
挤压
水加热
热负荷
验收试验
作者
Tilman Barz,Felix Hochwallner,Fabrizia Giordano,Raimund Zitzenbacher,Werner Pink,Esther Kieseritzky
标识
DOI:10.1016/j.applthermaleng.2026.133845
摘要
This paper presents, to the authors’ knowledge, the first systematic TRL 6 technology assessment of a novel phase-change-material-based heat pump water heater (PCM-HPWH) using R290 as refrigerant. The complete system prototype was tested in accordance with EN 16147, including continuous draw-off tests, standardized 24 h load profiles, off-peak operation, and standing-loss measurements, thereby demonstrating the domestic-hot-water performance of this emerging concept under realistic operating conditions. Unlike conventional HPWHs, the investigated prototype uses PCM integrated into densely finned aluminum flat multi-port extrusion (MPE) tube heat exchangers. The prototype passed the EN 16147 test for load profile L and provided sufficient storage capacity for load profile M in off-peak operation. However, the charging and discharging behavior of the PCM storage differed markedly from conventional water tanks, with the useful mixed-water volume strongly depending on draw-off rate, frequency, and pause duration. These results show that PCM-based HPWHs can meet standardized domestic-hot-water requirements, but that their usable storage capacity is highly sensitive to transient draw-off conditions. Consequently, while EN 16147 is useful for characterizing realistic use cases, its performance indicators are not fully suited for direct comparison with conventional water-based storage tanks.
科研通智能强力驱动
Strongly Powered by AbleSci AI