Transport of microplastics in stormwater treatment systems under freeze-thaw cycles: Critical role of plastic density

Stormwater treatment systems remove and accumulate microplastics from surface runoff, but some of them can be moved downward to groundwater by natural freeze-thaw cycles. Yet, it is unclear whether or how microplastic properties such as density could affect the extent to which freeze-thaw cycles would move microplastics in the subsurface. To examine the transport and redistribution of microplastics in the subsurface by freeze-thaw cycles, three types of microplastics, with density smaller than (polypropylene or PP), similar to (polystyrene or PS), or greater than (polyethylene terephthalate or PET) water, were first deposited on the top of packed sand-the most common filter media used in infiltration-based stormwater treatment systems. Then the columns were subjected to either 23 h of drying at 22 ⁰C (control) or freeze-thaw treatment (freezing at -20 ⁰C for 6 h and thawing at 22 ⁰C for 17 h) followed by a wetting event. The cycle was repeated 36 times, and the effluents were analyzed for microplastics. Microplastics were observed in effluents from the columns that were contaminated with PET and subjected to freeze-thaw cycles. Comparison of the distribution of microplastics in sand columns at the end of 36 cycles confirmed that freeze-thaw cycles could disproportionally accelerate the downward mobility of denser microplastics. Using a force balance model, we show that smaller microplastics (<50 µm) can be pushed at higher velocity by the ice-water interface, irrespective of the density of microplastics. However, plastic density becomes critical when the size of microplastics is larger than 50 µm. The coupled experimental studies and theoretical framework improved the understanding of why denser microplastics such as PET and PVC may move deeper into the subsurface in the stormwater treatment systems and consequently elevate groundwater pollution risk.