材料科学
沸腾
高温
热流密度
炸薯条
流动沸腾
热力学
流量(数学)
热流
核沸腾
临界热流密度
机械
焊剂(冶金)
碳化硅
传热系数
水冷
散热片
电子设备和系统的热管理
热撒布器
传热
复合材料
作者
Shasha Huo,Xinqiang Wang,Bo Sun
标识
DOI:10.1016/j.ijheatmasstransfer.2025.127885
摘要
• Phase-change microchannel cooling for third generation semiconductor chips. • The design achieves an exceptionally high critical heat flux of 1682 W cm −2 by leveraging two-phase flow boiling heat transfer. • A three-fold efficiency improvement over single-phase microchannels (COP over 19000). • Embedded hierarchical porous microchannel alleviates boiling instability. While Moore's Law has approached its physical limits lately, the high integration and miniaturization of electronics have also brought another thermal failure obstacle. Previous studies on single-phase flow demanded significant pump power to achieve higher Critical Heat Flux (CHF), which risked exceeding the chip's mechanical limits and complicating packaging. The elevated junction temperature (above 175°C) of third-generation semiconductors makes them ideal for two-phase water cooling, which utilizes the huge latent heat during boiling of water to minimize the flow rate and maximize the Coefficient of Performance (COP). In this work, we designed an embedded hierarchical microchannel heat sink for heat transfer by deionized water two-phase cooling. The combination of the distribution manifold and the hierarchical microchannel copper wick achieves a balance between a large number of nucleation sites and excellent permeability. We observed an CHF of 1682 W/cm 2 with COP up to ∼19000 at flow rate of 3.0 ml/s, which means Only 89 mW of power is needed to take away the heat flux of 1682 W/cm 2 on a chip, corresponding to a 3-fold increase compared to single-phase microchannels with the same flow rate. This technology is anticipated to overcome the bottleneck in electronic thermal management.
科研通智能强力驱动
Strongly Powered by AbleSci AI