火焰离子化检测器
热导检测器
化学
气相色谱法
产品分销
甲醇
分析化学(期刊)
二甲醚
色谱法
催化作用
有机化学
作者
Yuli Gao,Yingqian Cao,Sheng‐Li Chen,Ya Wang,Ruyue Zhu,Wei Sun,Qi Zhang,Yu Fan
出处
期刊:Energy & Fuels
[American Chemical Society]
日期:2017-11-09
卷期号:31 (12): 13266-13272
被引量:6
标识
DOI:10.1021/acs.energyfuels.7b02145
摘要
It is generally accepted that the products of dimethyl ether (DME)-to-olefins (DTO) and methanol-to-olefins (MTO) processes are hydrocarbons; therefore, gas chromatography (GC) equipped with a flame ionization detector (FID) rather than a thermal conductivity detector (TCD) is usually used to measure their product distribution for the higher response sensitivity of FID than TCD. Product distributions of DTO and MTO processes over SAPO-34 and metal-oxide-modified SAPO-34 catalysts were measured in this research work with GC equipped with FID and TCD. Results showed that product distribution over SAPO-34 measured with FID GC alone was similar to that measured with TCD + FID GC when the DME or methanol conversions were close to 100% and the main products were hydrocarbons, with only trace amounts of H 2 and carbon oxides in the products. When using metal-oxide-modified SAPO-34 as the catalyst, it was found that the product distribution measured by TCD + FID GC was greatly different from that measured by FID GC alone. A lot of H 2 and carbon oxides were detected with TCD + FID GC, which are missed when using the sole FID GC to analyze the products. The accurate measurement of the complete product distribution spectrum is of importance for not only the calculation of product yields, mass balance, and reaction heat but also the investigation of reaction mechanisms and reaction kinetics. It is strongly suggested that TCD + FID GC be used to analyze the product distribution of DTO and MTO processes, especially when SAPO-34 is promoted with other components.
科研通智能强力驱动
Strongly Powered by AbleSci AI