Electropolymerized Aniline-Based Stainless Steel Fiber Coatings Modified by Multi-Walled Carbon Nanotubes for Electroanalysis of 4-Chlorophenol

In this paper, a stainless steel fiber coated electropolymerized aniline, without and with carbon nanotubes (SS/PANI and SS/PANI/CNT), along with CNTs modified carbon paste electrodes (CPEs), were prepared. The electrodes were characterized by differential pulse voltammetry (DPV) and applied for the detection of 4-chlorophenol (4-CP). For all the electrodes, the oxidative peak current showed a linear dependence on the 4-CP concentration in the range of 0.05–0.5 mmol/L with R2 ≥ 0.991. SS/PANI/CNT electrodes showed greater sensitivity for the detection of the 4-CP than the SS/PANI and CPEs. For all of the aniline-based stainless steel electrodes, both the LOD and LOQ decreased with the increase in the number of electropolymerization cycles. The lowest LOD (0.38 µmol/L) and LOQ (1.26 µmol/L) were observed for the SS/PANI/CNT electrode modified in aniline solution during 30 cycles. The methods were successfully applied to the analysis of 4-CP in real samples (tap water and river water). The results demonstrated the good agreement of the added and found concentrations of the 4-CP. The recovery and precision were from 95.12% to 102.24% and from 1.53% to 6.79%, respectively. The proposed electrodes exhibited acceptable reproducibility, admirable stability, and adequate repeatability and showed potential for the analysis of 4-CP in water.