Hybrid filament-wound materials: Tensile characteristics of (aramide fiber/glass fiber)-epoxy resins composite and (carbon fibers/glass fiber)-epoxy resins composites

In this paper a tensile characteristics of filament-wound glass fiber-aramid fiber/epoxy resins hybrid composites and glass fiber-two carbons fibers/epoxy resins hybrid composites are presented. Basic terms about hybride composite materials (origin, reasons for manufacturing, advantages, definitions, levels of hybridization, modes of classifications, types, categorization, and possible interactions between constituents) and used reinforcements and matrices are described. For a manufacturing of NOL rings four reinforcements (glass fiber, polyamide aromatic fiber and two carbon fibers) and two matrices (high and moderate temperature curing epoxy resin system) are used. Based on experimentally obtained results, it is concluded that hybride composite material consisting of carbon fiber T800 (67 % vol) and glass fiber GR600 (33 % vol) impregnated with epoxy resin system L20 has the highest both the tensile strength value and the specific tensile strength value. The two lowest values of both tensile strength and the specific tensile strength have hybrid material containing aramide fiber K49 (33 % vol) and glass fiber GR600 (67 % vol) and epoxy resin system 0164 and hybrid NOL ring with wound carbon fiber T300 (33 % vol) and glass fiber GR600 (67 % vol) impregnated with the same epoxy resin system. This investigation pointed out that increasing the volume content of aramide fiberK49, carbon fiber T300 and carbon fiber T800 in appropriate hybrid composites with glass fiber GR600 increases both the tensile strength value and the specific tensile strength value and decrease the density value, no matter the used epoxy resin system.