Characterization of the keratin/polyamide 6 composite fiber's structure and performance prepared by the optimized spinning process based on the rheological analysis

The complex chemical structure of polypeptide and the imperfection of processing technology cause the mechanical properties of regenerated keratin to be hard and brittle. This defect seriously affects the application prospects of keratin materials. To solve the above problems, α-lipoic acid modified keratin (KER) was blended with Polyamide 6 (PA6) and prepared into composite fibers via the wet-spinning method in this work. The spinnability and spinning conditions of the KER/PA6 blend solution were analyzed by rheological theory. The results illustrated that keratin solution will easily form a gel state under certain temperatures and concentrations, which was not conducive to the preparation of regenerated fiber. When the temperature was 45 °C and the mass fraction was 10 %, the viscosity and rheology of the solution were appropriate. The rheological properties of the blend solution showed that too much keratin would make the solution easy to gel, which was not conducive to the preparation of regenerated fibers and may affect the fiber properties. On this basis, the prepared composite fibers were characterized to explore the macromolecular aggregation state of keratin and PA6 in fibers. FT-IR and XRD results proved that there was no chemical reaction between keratin and PA6 in the composite fibers, which belonged to physical blending. At the same time, the two polymers had good compatibility and can be blended at the molecular level. SEM, DSC, and tensile strength test results indicated that when the proportion of keratin was too high, the structure and properties of the composite fibers will have obvious defects, which was consistent with the rheological analysis. Therefore, the blend ratio of keratin/PA6 was determined to be 3:7. Under this condition, the fibers exhibited a homogeneous structure and good thermal properties, especially its mechanical properties were close to wool fibers. The KER/PA6 composite fibers show important research value and can also provide technical reference for the development of regenerated biomass materials.