Influence of Cr + Si content variation on cutting behavior of TiAlCrSiN HPPMS coatings

As high power pulse magnetron sputtering (HPPMS) technology is becoming popular in cutting tool industry, the development of nanocomposite coating systems such as TiAlCrSiN with this technology presents a new research avenue. Hereby, the combined effect of Cr and Si contents on properties and cutting behavior of high Al content TiAlCrSiN HPPMS coatings needs further investigation. For this purpose, three HPPMS coatings with Al/Ti ratio x = 1.4–1.5 and varying Cr + Si content, namely (Ti28Al40Cr16Si16)N, (Ti30Al43Cr17Si10)N and (Ti36Al54Cr5Si5)N, were deposited on cemented carbide substrates. In addition to basic characterization, the fracture behavior of the coatings was characterized by scratch tests. The cutting behavior of the coated inserts was exemplarily investigated during dry cutting of normalized medium carbon steel C45 with cutting speed vc = 80 m/min, feed rate f = 0.12 mm and cutting depth ap = 0.8 mm. The tool damage over the cutting time of tc = 35–40 min, as per the tool condition, was observed using light microscopy. Moreover, the damage mechanisms were analyzed in detail at the end of the cutting test using scanning electron microscopy. All coatings showed comparable indentation hardness HIT and indentation modulus EIT. However, an increased Cr + Si content amplified the brittle fracture of the coating under sliding load of scratch test. Moreover, the workpiece material C45 showed a higher adhesion tendency to cutting insert with high Cr + Si content TiAlCrSiN coatings during cutting tests. The tool wear and built-up edge formation increased due to the combined effect of workpiece adhesions and amplified brittle fracture of the coating at considered cutting speed. On the other hand, the inserts with low Cr + Si content coating exhibited better cutting performance and reduced built-up edge formation based on the improved fracture behavior of the coating and lower adhesion tendency of workpiece material to the corresponding coated insert.