石墨烯
循环伏安法
材料科学
X射线光电子能谱
超级电容器
傅里叶变换红外光谱
拉曼光谱
氧化物
扫描电子显微镜
介电谱
硼
氧化硼
分析化学(期刊)
电化学
电极
化学工程
无机化学
化学
纳米技术
有机化学
物理化学
复合材料
物理
工程类
光学
冶金
作者
Surya Sekar,Arumugam Pandurangan,Govindaraj Rajamanickam
标识
DOI:10.1080/1536383x.2023.2213359
摘要
The combination of boron and sulfur incorporated reduced graphene oxide (B/S-rGO) was synthesized by a simple hydrothermal technique using a novel and single source of thiophene-2 boronic acid pinacol ester. Structural and functional groups of the synthesized materials were analyzed by X-ray diffraction (XRD) and Fourier transform infrared (FTIR) spectroscopy analysis. The Raman analysis revealed the defective structure after incorporating sulfur and boron elements into rGO. The morphological and the presence of elements in the synthesized material were analyzed by scanning electron microscopy, transmission electron microscopy and elemental mapping analysis. The chemical states and chemical composition of B/S-rGO were observed by X-ray photoelectron spectroscopy (XPS) analysis. The electrochemical performance of the prepared material was studied using cyclic voltammetry (CV), galvanostatic charge-discharge (GCD) and electrochemical impedance analysis. GCD studies were performed for B/S-rGO electrode material in an aqueous 1 M H2SO4 electrolyte. The prepared material showed a high specific capacitance of 345 Fg−1 at 1 Ag−1 in a three-electrode configuration. B/S-rGO based device exhibited 97 Fg−1 of specific capacitance at 1 Ag−1 in a symmetric two-electrode configuration. B/S-rGO based symmetric device showed a high energy density of 13.4 Whkg−1 at 249 Wkg−1 and more than 96% capacity retention after 5000 cycles.
科研通智能强力驱动
Strongly Powered by AbleSci AI