Microstructure, mechanical and corrosion study of friction stir processed Inconel 625 additive layers deposited via wire arc direct energy deposition

This study explores the application of friction stir processing (FSP) as an effective post-deposition surface treatment technique for improving the mechanical and corrosion properties of wire arc direct energy deposited (WA-DED) Inconel 625 additive layers. The coarse and cube-oriented microstructure observed in as-built Inconel 625 components results in anisotropic mechanical properties. The non-equilibrium solidification in WA-DED Inconel 625 leads to severe micro-segregation of alloying elements, forming large Nb and Mo-rich Laves and carbide phases in the inter-dendritic areas. This causes a heterogeneous distribution of vital alloying elements within the γ-Ni matrix of the material, adversely affecting its mechanical properties and corrosion resistance, thereby restricting the utility of this manufacturing technique in critical applications. The incorporation of FSP has been observed to successfully eradicate the presence of typical coarse and highly oriented microstructure through grain refinement, achieving a more uniform microstructure. Through severe plastic deformation (SPD), coarse eutectic phases are broken down and redistributed within the γ-Ni matrix, enhancing the uniformity of material properties. The research thoroughly investigates the changes in microstructure, mechanical performance, and corrosion resistance of both WA-DED and FSP-enhanced WA-DED Inconel 625 samples. A Thermo-Calc simulation using the classical Scheil model was conducted to understand the solidification pathway and the formation mechanism of the Laves phase in the WA-DED sample. The grain size was significantly reduced by 98.23%, from 138 µm in the WA-DED sample to 2.44 µm in the stir zone (SZ) of the FSP-treated area, due to dynamic recrystallization (DRX), particle-stimulated nucleation (PSN), and the Zener pinning effect. This grain refinement led to remarkable enhancements in the yield strength (YS) by approximately 113%, ultimate tensile strength (UTS) by about 37% and micro-hardness by around 60% compared to the WA-DED sample. In a 3.5 wt% NaCl solution, the FSP-treated sample demonstrated superior corrosion resistance by forming a stable, thicker passive film than the as-built sample. The results of this study will offer valuable insights into utilizing the FSP technique as post-weld surface treatment of WA-DED deposited IN625 superalloy.