The effects of macro-and micro-leveling agents and current density on surface smoothness of copper micro-bump were studied. The action mechanism of the two types of leveling agent and current density on copper micro-bump surface was discussed. The composition of plating bath and process parameters are as follows: CuSO 4 75 g/L, H 2 SO 4 100 g/L, Cl- 50 mg/L, leveling agents H and W 0-10 mg/L, temperature 25±2 °C, stirring rate 60 r/min, current density 1-8 A/dm 2,and time 35 min. The results show that the macro-leveling agent promotes copper deposition, while the micro-leveling agent inhibits copper deposition. The coordination of the two leveling agents changes the distribution of electronic lines in the pore during plating process, making the current density evenly distributed. Raising current density in certain range improves the formation of copper micro-bumps. The copper micro-bump with fine crystals and smooth surface can be obtained with both leveling agents (5 mg/L for each) at the current density of 6 A/dm 2 .