Design relation and end correction formula for multi-orifice Helmholtz resonators with intrusions

Helmholtz resonators are used to control low-frequency noise in cavities. One of the ways to reduce the resonance frequency of a resonator without changing its volume is to introduce an intrusion. Similarly, the introduction of multiple orifices can increase the resonance frequency without changing the resonator volume. These features provide an ability to accommodate slight changes in the cavity/enclosure frequencies during the design process. However, one has to rely on extensive three-dimensional finite element or boundary element simulations to predict the resonator characteristics with the introduction of these features. To reduce the computational burden, a design relation, between the first resonance frequency of a single orifice intruded resonator with that of a multi-orifice intruded resonator, is proposed in this paper. In developing this design relation, the total cross-sectional area of the resonator with multiple orifices is the same as that of the single orifice resonator. It is shown that this design relation is independent of the shape/size of the orifices and resonator cavity. Using this relation, a new end correction formula for the orifice lengths of multi-orifice intruded resonators has been proposed. The end correction formula can be used to calculate the reactance of multi-orifice intruded Helmholtz resonators analytically. These expressions are derived by carrying out extensive simulations of the resonators using the boundary element method. Limited experiments have been carried out to validate the proposed approach. The use of these expressions will reduce the computational cost of simulating cavities embedded with resonators as one can avoid modeling the resonators and use impedance boundary conditions instead.