Diazo-Based Copolymers for the Wet Strength Improvement of Paper Based on Thermally Induced CH-Insertion Cross-Linking

High Resolution Image Download MS PowerPoint Slide We present an alternative to commonly used, but from an environmental point of view, problematic wet strength agents, which are usually added to paper to prevent a loss of mechanical stability and finally disintegrate when they get into contact with water. To this end, diazoester-containing copolymers are generated, which are coated onto paper and by heating to 110–160 °C for short periods of time become activated and form carbene intermediates, which undergo a CH-insertion cross-linking reaction. The process leads to a simultaneous cross-linking of the polymer and its attachment to the cellulose substrate. The immobilization process of copolymers consisting of a hydrophilic matrix based on N, N -dimethylacrylamide and a diazoester-based comonomer to a cellulose model surface and to laboratory-engineered, fibrous paper substrates is investigated as a function of time, temperature, and cross-linker composition. The distribution of the polymer in the fiber network is studied using confocal fluorescence microscopy. Finally, the tensile properties of modified wet and dry eucalyptus sulfate papers are measured to demonstrate the strong effect of the thermally cross-linked copolymers on the wet strength of paper substrates. Initial experiments show that the tensile indices of the modified and wetted paper samples are up to 50 times higher compared to the values measured for unmodified samples. When dry and wet papers coated with the above-described wetting agents are compared, relative wet strengths of over 30% are observed.