Photocatalytic Dehydrogenation of Primary Alcohols: Selectivity Goes against Adsorptivity

Solid/liquid heterogeneous photocatalysis was often considered to occur on the active sites of a solid catalyst surface. Herein, we report that the selectivity of photocatalytic dehydrogenative oxidations of aliphatic primary alcohols in acetonitrile solution into corresponding aldehydes exhibits an anomalous relationship with adsorption behavior of the alcohols. By using Pt-loaded TiO2 photocatalyst in an inert atmosphere under UV light illumination, primary short-chain alcohols (SCAs) with strong adsorption were dehydrogenated into aldehydes in very poor selectivity, whereas weak-adsorbable long-chain alcohols (LCAs) were transformed into corresponding aldehydes with much higher selectivity. More than 20 examples of primary LCAs (C4-C10) were successfully transformed into their corresponding aldehydes with satisfactory selectivity and yield. Both solid-state magic-angle-spinning 13C NMR and attenuated total reflectance-Fourier transform infrared spectroscopy studies provided concrete differences in adsorption behaviors on the Pt-TiO2 photocatalyst surface between SCA ethanol and LCA n-octanol. To further uncover the mechanism for different selectivities of SCAs and LCAs in photodehydrogenation, in situ electron paramagnetic resonance (EPR) experiments (at 8 K temperature) were employed to observe the oxidation features of photogenerated hole in the valance band of Pt-TiO2 (hvb+). The EPR experimental studies exhibited that unlike ethanol, either n-octanol or solvent acetonitrile alone all could not scavenge photogenerated hvb+ on Pt-P25 photocatalyst and only n-octanol dissolved in acetonitrile solvent could smoothly react with photoinduced hole. This indicated that selective oxidations of LCAs were achieved by solvent-delivered oxidation rather than directly destructive oxidation of photogenerated hvb+. Our results may open an alternative way in selective dehydrogenative oxidation of various substrates sensitive to both dioxygen and high-temperature treatments.