Surface modification of anhydrous phosphogypsum and its application in isotactic polypropylene

Phosphogypsum (PG) is a by-product of the wet phosphoric acid process, and anhydrous phosphogypsum (APG) prepared by PG calcination and ball milling pretreatment can be useful to prepare polypropylene composites by melt blending to yield polymer materials with improved properties. In this work, the hydrophobic effect of stearic acid (SA) modified APG was investigated by various analytical techniques. To this end, the modified APG was used as a filler for isotactic polypropylene (PP) blending to yield PP/APG composites and study the influence of APG particle size and added amount on the mechanical properties of PP/APG composites. The results showed SA coated on APG surface by chemical adsorption to form a hydrophobic layer. The water contact angle increased from 8.49° to 112.49° before to after modification, respectively. The mechanical properties of PP/APG composites were affected by the particle size and content of APG. Smaller particle size of APG led to better mechanical properties of PP/APG composites. At particle size d 50 of APG filler of 2.83 μm and content of 5 wt%, characteristics like the tensile strength, flexural strength, impact strength, and tensile modulus of PP/APG composites reached 37.28 MPa, 47.71 MPa, 6.18 KJ/m 2 , and 422.3 MPa, respectively. Compared to pure PP, these values increased by 4.66%, 5.4%, 27.68%, and 18.28%, respectively. Smaller particle size of APG was also found more conducive to the increase in APG content within PP/APG composites, as well as reduced production cost of composites. APG prepared from PG after treatment is useful as a filler for PP and other polymer materials, promising for PG resource utilization.