Preparation and Characterization of a Composite Dust Suppressant for Coal Mines

In an effort to effectively control coal dust pollution and thereby reduce the harm of coal dust to human health, we prepared a highly efficient composite dust suppressant. First, dynamic contact angle and zeta potential measurements were used to select sodium dodecyl sulfonate (SDS) over sodium carboxymethyl cellulose and trisodium methyl silicon as the complementary additive to soy protein isolate for the dust suppressant. We employed viscosity and wind erosion resistance tests to compare the performance of the composite dust suppressant with three common, commercially available suppressants. As the concentration of the composite dust suppressant was increased, the viscosity increased, reaching a maximum value of 22.7 mPa·s at a concentration of 5 wt%. The 5 wt% concentration of the composite dust suppressant provided the lowest wind erosion rate (20.62%) at a wind speed of 12 m/s. The composite dust suppressant also had good bonding performance and wind erosion resistance. Scanning electron microscopy, X-ray diffraction, and thermogravimetric analysis were used to characterize the properties of the dust suppressants. The dust suppressant, which had a crystal-like structure, could easily capture coal dust and form an effective package. In addition, the density of the dust suppressant film increased as its crystallinity increased. The increased density was beneficial in that it enabled the dust suppressant to form a hard, solidified shell on the surface of coal dust, which improved dust suppression. The composite dust suppressant also had good thermal stability.