Impact of cage position on biomechanical performance of stand-alone lateral lumbar interbody fusion: a finite element analysis

This study aimed to compare the biomechanical performance of various cage positions in stand-alone lateral lumbar interbody fusion(SA LLIF).An intact finite element model of the L3-L5 was reconstructed. The model was verified and analyzed. Through changing the position of the cage, SA LLIF was established in four directions: anterior placement(AP), middle placement(MP), posterior placement(PP), oblique placement(OP). A 400 N vertical axial pre-load was imposed on the superior surface of L3 and a 10 N/m moment was applied on the L3 superior surface along the radial direction to simulate movements of flexion, extension, lateral bending, and axial rotation. Various biomechanical parameters were evaluated for intact and implanted models in all loading conditions, including the range of motion (ROM) and maximum stress.In the SA LLIF models, the ROM of L4-5 was reduced by 84.21-89.03% in flexion, 72.64-82.26% in extension, 92.5-95.85% in right and left lateral bending, and 87.22-92.77% in right and left axial rotation, respectively. Meanwhile, ROM of L3-4 was mildly increased by an average of 9.6% in all motion directions. Almost all stress peaks were increased after SA LLIF, including adjacent disc, facet joints, and endplates. MP had lower stress peaks of cage and endplates in most motion modes. In terms of the stress on facet joints and disc of the cephalad segment, MP had the smallest increment.In our study, SA LLIF risked accelerating the adjacent segment degeneration. The cage position had an influence on the distribution of endplate stress and the magnitude of facet joint stress. Compared with other positions, MP had the slightest effect on the stress in the adjacent facet joints. Meanwhile, MP seems to play an important role in reducing the risk of cage subsidence.