Erosion Behavior of Stellite-6 and WC-12Co Coatings on SA213-T22 Boiler Steel

At Mae-Moh power plant, Thailand, superheater tubes, which are exposed to a fly ash environment, often degrade due to solid particle erosion. To extend the service lifetime of the superheater tubes, the high velocity oxy-fuel (HVOF) thermal spray technique is used to deposit a protective coating on the material, SA213-T22 steel. In this work, the solid particle erosion of Stellite-6 and WC-12Co coatings was investigated using erodent particle impingement at angles of 30 and 90°. This was carried out with an average particle size of 60 μm. The erosion behavior of SA213-T22 with and without Stellite-6 and WC-12Co coatings was examined using ductile and brittle erosion modes. The erosion testing resulted in the brittle mode for both Stellite-6 and WC-12Co coatings, while the SA213-T22 without coating indicated the ductile mode. On investigation of the surface morphology, the SA213-T22 steel showed ploughing and microcutting. The Stellite-6 coating showed some evidence of ductile erosion such as lips on the coating surface, different from the WC-12Co coating which showed microcracks and deep cavities. The erosion resistance of the Stellite-6 coating was higher than the WC-12Co coating. This was due to the strength and toughness of the metal matrix composite structure and the low porosity of the coating.