Virus Behavior after UV254 Treatment of Materials with Different Surface Properties

The COVID-19 pandemic highlighted the limitations in scientific and engineering understanding of applying germicidal UV to surfaces. This study combines surface characterization, viral retention, and the related UV dose response to evaluate the effectiveness of UV254 as a viral inactivation technology on five surfaces: aluminum, ceramic, Formica laminate, PTFE and stainless steel. Images of each surface were determined using SEM (Scanning Electron Microscopy), which produced a detailed characterization of the surfaces at a nanometer scale. From the SEM images, the surface porosity of each material was calculated. Through further analysis, it was determined that surface porosity, surface roughness, contact angle, and zeta potential correlate to viral retention on the material. The imaging revealed that the aluminum surface, after repeated treatment, is highly oxidized, increasing surface area and surface porosity. These interactions are important as they prevent the recovery of MS-2 without exposure to UV254. The dose response curve for PTFE was steeper than ceramic, Formica laminate and stainless steel, as inactivation to the detection limit was achieved at 25 mJ/cm2. These findings are consistent with well-established literature indicating UV reflectivity of PTFE is maximized. Statistical testing reinforced that the efficacy of UV254 for surface inactivation varies by surface type.