A 5-kV pulse generator with a 100-kV/µs slew rate based on series-connected 1700-V SiC MOSFETs for electrical insulation tests

This study demonstrates a high-slew-rate 5-kV pulse generator for electrical insulation tests. Electrical equipment, such as electrical actuators and traction drive motors, are exposed to severe electrical stress because recent switching inverters have high-frequency outputs with high supply voltages using wide-bandgap power devices. For an advanced electrical insulation test, a high-voltage pulse generator is required with a high slew rate; however, such generators suffer from large switching noise, followed by measurement noise, such as ground voltage fluctuations and radiation noise, hindering the detection of partial discharge (PD) phenomena. In this study, we propose a 5-kV pulse generator based on series-connected 1700-V silicon carbide (SiC) metal-oxide-semiconductor field-effect transistors (MOSFETs). Four 1700-V SiC MOSFETs are connected in series as a 5-kV SiC switching module, constituting a half-bridge configuration for the pulse generator. The obtained switching waveforms exhibit fast rise times of 48 ns under 5 kV and 6.2 ns under 400 V with a low voltage overshoot and ringing owing to superior device characteristics and reduced parasitic inductances. Because of the low switching noise, we detect a clear PD signal with a 1500-V pulse when using the fabricated pulse generator for a PD test of a twisted pair. The proposed pulse generator uses a hard switching configuration such that the pulse generator can vary the pulse width from 150 ns to DC and increase the switching pulse cycle beyond 1 MHz by changing the control signals of the SiC MOSFETs.