Air polishing with erythritol powder – In vitro effects on dentin loss

Low-abrasive polishing powders such as glycine (GLY) or erythritol (ERY) are used for subgingival air polishing. GLY was reported to possibly affect the dentin surface, while this is unclear for ERY.This in vitro study aimed to evaluate the substance loss from the dentin surface by air polishing with ERY at different settings for pressure (PR), distance (DI), and angulation of the spray jet to the surface (AJ).The in vitro testing was performed on smooth human root dentin surfaces. In 18 groups with 10 specimens each, ERY was applied with constant water supply for 5 s without moving the handpiece at the following settings: PR minimum (min), medium (med), and maximum (max); DI at 1, 3, and 5 mm; and 45° or 90° AJ. The substance loss was measured as defect depth (DD) using three-dimensional (3D)-laser profilometry. ANOVA with Bonferroni correction and α = 0.05 were used for statistical analysis.The DD was statistically significantly higher at a DI of 1 mm compared to a DI of 5 mm for the respective groups of the same PR and AJ (P < 0.05). For DI 1 mm, max PR, and AJ 90°, the maximum loss of substance amounted DD of 117 ± 43 μm. The minimal loss of substance occurred at minimal PR, 45° AJ, and a DI of 5 mm (15 μm × 20 μm). DD related directly with the parameters PR and AJ and inversely with DI. The highest influence on DD was proven for DI.Slight loss of dentin might occur during air polishing with ERY depending on DI, PR and AJ. The setting influences the amount of dentin loss.