An experimental test was performed to extend the parameter range covered in the Stanford flow-tube reactor to lower gas temperatures (and thus lower particle heating rates). This experiment is intended to complement modeling efforts on the localized oxidation of pyrolysis products, particularly ''tarry volatiles'', during the early stages of pulverized coal combustion. Two important parameters of interest are the bulk gas oxygen concentration, and the particle heating rate. The effect of the particle heating rate is expected to be observed through its influence on the distribution and yield of pyrolysis products. The determination of this effect is the limiting factor at the current stage of this investigation, since this information is a necessary input into the diffusion-limited shrinking sphere model for tar oxidation which has been developed. This model has shown a reasonable prediction of the oxygen concentration dependence for the carbon conversion rates at one gas temperature, 1750K. The application of this model to a range of temperatures is not yet possible due to the lack of information on the effect of the heating rate (i.e., gas temperature) on the tar yield. Future efforts will be centered around the measurement of tar yields through the examination of particle samplesmore » oxidized at a variety of bulk gas temperatures. The analysis of micro-samples for carbon, hydrogen, and ash content will also be performed. The ultimate goal of this model will be to understand the carbon conversion rates observed in the Stanford flow-tube reactor, and to assess the degree to which energy feedback contributes to the high reactivities observed. 6 figs.« less