作者
A. M. Al Dhamen,F. Alomran,R. Asiri,S. Alshammari,Subhash Ayirala
摘要
Abstract Oilfield produced water is generated in very large volumes and represents a potential unconventional lithium resource, but its high ionic strength and strong competition from Na+, Mg2+, and Ca2+ make direct lithium extraction challenging. In this study, a standardized, delithiation-normalized batch protocol was developed to benchmark lithium ion sieves (LIS) under a synthetic produced-water matrix (TDS = 2.53 × 105 mg/L) with fixed major ions (Na+, K+, Mg2+, Ca2+, Ba2+) and systematically varied operating conditions relevant to deployment. Three LIS materials, lithium titanate (LT), lithium titanate spinel (LTSO), and lithium manganese oxide (LMO), were evaluated alongside lithium zirconate (LZ) as a non-LIS comparator. Across dosage (S:L = 1–5 g/L), pH (6–9), contact time, initial Li⁺ (1–300 mg/L), temperature (25–70 °C), and regeneration testing, ion chromatography was used to quantify equilibrium capacity (q), distribution coefficients (Kd), selectivity factors (Li/Na, Li/Mg), and kinetic and diffusion diagnostics (PFO/PSO, Weber–Morris, Boyd). Under the produced-water matrix, LT consistently showed the strongest Li partitioning and highest capacities, followed by LTSO and then LMO, while LZ exhibited no measurable Li uptake and was excluded from isotherm and selectivity analysis. Uptake increased with pH and temperature for all LIS, with selectivity showing comparatively weak temperature sensitivity. Kinetic and diffusion analyses indicated rapid initial uptake followed by a slower approach to equilibrium with mixed control, consistent with contributions from both film and intraparticle resistances under the applied mixing. Isotherm fits (Langmuir, Freundlich, Sips, Temkin) supported saturating, site-limited uptake behavior over the tested concentration window, though parameter identifiability was limited by four concentration levels. Two-cycle testing showed high short-term retention (98.0% for LT, 97.4% for LTSO, 92.9% for LMO), indicating largely reversible performance after one regeneration step. Overall, the controlled produced-water benchmarking framework provides like-for-like performance metrics and highlights the coupled roles of selectivity, kinetics, and stability in evaluating LIS for high-salinity brines.