Dual-sliding mode approach for separated fault detection and tolerant control for functional safety of longitudinal autonomous driving

This paper describes model-based separated fault detection and fault tolerant control of longitudinal autonomous driving using dual-sliding mode observer for functional safety. Internal and environment sensors such as camera or radar are required to measure the acceleration information of the subject vehicle and the relative distance and velocity information between the preceding and subject vehicles in longitudinal autonomous driving. In order to detect the independent fault of each sensor, a dual-sliding mode observer (SMO) is used for fault reconstruction under the assumption that V2V (Vehicle to Vehicle) communication for vehicle driving state is available. The each SMO reconstructs the expected fault in sensor based on discontinuous injection term used for converging output error to zero. Based on the reconstructed fault by each SMO, faults are detected using threshold approach. When the fault is detected, the reconstructed fault is used for fault tolerant control by subtracting to faulty data. The proposed fault detection (FD) and fault tolerant control (FTC) algorithms were evaluated using actual driving data and a three-dimensional (3D) vehicle model with a linear quadratic regulator for following control. The evaluation results are presented and analyzed with regard to fault reconstruction, detection, and tolerant control in four cases wherein two types of faults were applied.