球(数学)
端铣
材料科学
机械加工
表面粗糙度
表面光洁度
立铣刀
合金
常量(计算机编程)
工程制图
机械工程
几何学
冶金
复合材料
计算机科学
数学
工程类
程序设计语言
作者
Ján Varga,Teodor Tóth,Ľuboš Kaščák,Emil Spišák
出处
期刊:Applied sciences
[Multidisciplinary Digital Publishing Institute]
日期:2022-10-21
卷期号:12 (20): 10638-10638
被引量:16
摘要
The article discusses the effect of milling strategies on surface quality and geometric deviations during pocket milling when the perpendicular position of the tool is used. For experimental research, an aluminum alloy, AlCu4Mg, was used. For the production, a three-axis milling machine was used, and consequently, the geometric deviations and roughness parameters of the machined surface were evaluated. Also, the surface texture from each strategy was compared. For the production strategy, the constant Z, circular pocket, constant stepover pocket auto border, and spiral strategies were used. The geometric characteristic evaluation showed the influence of the ball end mill used in the machining process. Constant Z strategy achieved the lowest shape deviations. In the spiral strategy, it was possible to observe an effect of plowing, where the cutting tool crushed the material at the tool center. There was a minimal effect on the surface texture in the circular pocket and constant stepover pocket auto border strategies. Using the constant Z strategy, a non-oriented surface texture was obtained. 3D maps of the extracted residual scallop height for each strategy were observed when examining the surface texture. The roughness parameters Ra and Rz for the circular pocket and constant stepover pocket auto border strategies were the lowest.
科研通智能强力驱动
Strongly Powered by AbleSci AI