作者
Caleb Stone,Lakshmi Surag Singavarapu,Ayush Morchhale,Ram Lalgudi,Yehia M. Khalifa,Jung‐Hyun Kim,Jay R. Sayre
摘要
Polymer composite electrolytes must exhibit multifunctional stability, maintaining mechanical, thermal, and electrochemical properties, while also achieving high ionic conductivity. A composite polymer electrolyte (CPE) incorporates a highly conductive, flexible polymer matrix combined with ceramic loading to enhance ionic conductivity and specific capacity in LiFePO 4 (LFP)/Li solid-state battery (SSB) cells. Characterizing the effect of ceramic loading has on multifunctional stability provides insights into CPE design and optimization. In this work, we examined a series of CPEs, synthesized by blending polyethylene oxide (PEO), polyethylene glycol dimethyl ether (PEGDME) and lithium bis(trifluoromethanesulfonyl) imide (LiTFSI), with Li 6.4 La 3 Zr 1.4 Ta 0.6 O 12 (LLZTO) at 10, 20, and 30 wt.%. X-ray diffraction (XRD) and differential scanning calorimetry (DSC) analysis reveal that LiTFSI, PEGDME, and LLZTO each The electrochemical impedance spectroscopy (EIS) results show a marked reduction in both interfacial and bulk resistances with increasing LLZTO content, leading to an improvement in ionic conductivity. In particular, the 30 wt.% LLZTO CPE exhibited a conductivity of 2.25×10 −4 S/cm at 40°C, representing a 70.23% improvement over the 20 wt.% LLZTO CPE, which exhibited a conductivity of 1.38×10 −4 S/cm at 40°C. The baseline PEO-PEGDGME-LiTFSI polymer electrolyte, without any LLZTO, exhibited an ionic conductivity 0.97x10 -4 S/cm at 40°C. Long-term cycling performance in Li/CPE/Li symmetric cells demonstrated operation for up to 1,000 cycles without failure for 0, 10 and 20 wt.% LLZTO CPE. For instance, the 20 wt.% LLZTO CPE maintained a total resistance less than 1 kΩ after 1000 cycles, measured at room temperature. However, the 30 wt.% LLZTO CPE showed signs of short-circuiting after 550 cycles. Its severe LLZTO agglomeration and the presence of uncoated LLZTO at the solid electrolyte interface, as confirmed by scanning electron microscopy (SEM) and X-ray photoelectron spectroscopy (XPS), may promote Li dendrite growth along the grain boundaries of LLZTO. Our results suggest that the 20 wt.% LLZTO CPE offers optimal long-term mechanical, thermal and electrochemical stability while maintaining low total resistance, compared to other compositions tested, delivering a specific capacity of 150.87 mAh/g at C/5 charging rate in a LFP/Li SSB cell. The effect of LLZTO CPE compositions on capacity retention and Coulombic efficiency of SSB cells and key design parameters for stable CPEs will be discussed, with an emphasis on enhancing the Li/CPE interfacial stability, thereby improving the performance of SSBs.